QZtr-2H607 Three-in-one Stepper Driver
QZtr-2H607A is equal to three pieces of QZ-2H606A. Their parameters and performance are completely same. The driver has no DIP switches. The parameter can be set by the cutting controller or programmer. Its size is small and it's easy to install. It's good to be be used for 3-axis machine or dual-drive machine.
Current waveform diagram
The following are current waveform pictures of QZtr-2H607 Three-in-one Stepper Driver tested under the same condition. Pictures are taken by the oscilloscope without any amendment.
Three-in-one Stepper Driver
QZtr-2H607A is equal to three pieces of QZ-2H606A.Its size is small and it's easy to install. It's good to be be used for 3-axis machine or dual-drive machine.
★ accurate sine current control brings excellent performance
★ 255 options of steps for different transmission ratio
★ automatically record the breaking point when power off
★ set the rotation direction of the motor
★ input signal 5V, can be adjusted to 12V or 24V by external current limiting resistors
★ perfect stability, low-speed mute, extremely low heat productivity
★ 16 kinds of lock time (0.1~2 seconds)
★ set EN port to off-line mode or lock mode
★ single pulse, dual pulse
★ 11 kinds of lock current (0~100%)
★ 16 kinds of output current
★ easily set and read
★ auto run function
★ self-test ability
★ protection function
★ work on drive technology for 30 years
The final interpretation rights belong to StatAi, and the above models and parameters are for reference only.